AirLink Communications Raven X HSDPA Guia do Utilizador descarregar pdf (Página 28)

Raven X HSUPA

20 20070914

• The Reset button (on the left side of the Raven X) has two functions. If it is

quickly depressed and released, the modem will simply power cycle the

internal hardware. If, however, the reset is depressed and held for several

seconds (count 10 slowly, and wait for the power light to go off after the light

pattern stops), the ALEOS configuration settings will return to the factory

defaults.

Light Patterns

The LEDs on the front of the modem will respond in different patterns to indicate

modem states.

• Normal - Each LED, mentioned above, is lit as applicable.

•Start up - The LEDs will cycle from left to right.

• PassThru mode - Network and Signal LEDs will blink in tandem. The

Activity LED will blink when transmitting or receiving data.

•SOS - The Network Channel and Service Err or Service LEDs will blink

alternate to each other.

• Configuration Reset - The LEDs will cycle left to right and then right to left 4

times.

• Authentication Failure - The Network, Signal, and Activity LEDs blink every

2 seconds.

• Data Retry - The Network, Signal, and Activity LEDs blink every 3 seconds.

• Invalid MAC Address or Ethernet Initiation Fail - The Service LED will

blink.

Caution:

If you reset the modem configuration using the reset button,

you may to reconfigure your APN.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Sem comentários

AirLink Communications Raven X HSDPA Guia do Utilizador Página 28